home *** CD-ROM | disk | FTP | other *** search
/ NetNews Offline 2 / NetNews Offline Volume 2.iso / news / comp / sys / amiga / hardware-part1 / 2948 / text0000.txt < prev   
Encoding:
Text File  |  1996-08-05  |  1.6 KB  |  31 lines

  1. Arthur Hoffmann wrote:
  2. > I made a cable to connect a 50pin header cable to the external db25pin
  3. > connector on the Amiga3000. This cable runs into an external box that
  4. > has it's own power supply and contains a SCSI Tape and a HD.
  5.  
  6. > Now a friend wants me to connect my external scsi box, to his GVP IO
  7. > extender to make use of my Tape and the drive in my the box, on his
  8. > computer, which is an A2000 with a GVP.
  9. > Can my box just be plugged in or do I have to make a cable again that
  10. > conforms to the GVP.
  11.  
  12. Arthur:
  13.  
  14. Phil Wright makes a good point in his reply; namely that the GVP I/O extender is a 
  15. serial/parrallel port extender, not a SCSI controller.  However, I will assume you 
  16. meant that your pal has a GVP Imact series I or II Hard Card installed in his A2000.  
  17. With that in mind, I can tell you that a cable which will run your hard drives and 
  18. tape drive from the DB-25 connector on the back of the A3000 will also run those same 
  19. hard drives and tape drive when connected to the DB-25 connector on the back of a GVP 
  20. SCSI hard card.  I have done this with both the hard card (Zorro slot) version of the 
  21. GVP controller and the A500 HD+ and A530 turbo controllers.  (In fact, you could even 
  22. chain 2 of the A500 HD+ units together, so long as only one was actually connected to 
  23. an A500...  Connected with a standard parrallel cable, the unit connected to the 500 
  24. motherboard was able to see the drive in the second unit sitting next to it, and since 
  25. the second unit wasn't connected to a motherboard, it's SCSI controller never 
  26. initialized.  Neat!)
  27.  
  28. Adam Burns   aka...
  29. The Buffo Mounie
  30.